SupplierNet | Clearfield | Quality Assurance
The Aerojet East quality provisions are found in the form listed as A-24 noted below.
These provisions define the parameters of the inspection and certification requirements
required as part of any request for cost information and any resulting purchase order.
The respective purchase order or request for cost information sent to you will define which
revision (by date) you should utilize in the performance of your efforts. Should you
encounter questions regarding the use or submission of data relative to this document,
please contact the buyer as noted in purchase order or request for cost information.
Unless otherwise noted, the latest dated revision should be used for the submission of documentation.
A-24 (July 17, 2008)
A-24 (June 12, 2008)
(May 17, 2007)
When a quality assurance specification is defined in a purchase order, the
supplier's quality assurance system must meet the requirements of that specification.
The level of the quality or inspection system required will depend upon the type
of hardware being procured. Approval of the supplier's quality system may be
obtained through an on-site survey of the supplier's plant by an Aerojet Quality
Assurance Representative, through evaluation of the supplier's quality assurance
procedure or through evidence of acceptability of the supplier's quality or inspection
system to other industry prime contractors.
As an additional assistance we have also provided detailed instructions for the completion of Aerojet
certifications as referenced in the A-24. These instructions can be found by
reviewing the attached documents:
QAP-E-10 Instructions
QAP-E-3 Instructions
Contact Bob Stets (801-774-2417),
him, or contact the buyer identified in the RFQ or purchase order if you require
additional information regarding supplier quality assurance requirements.
Purchasing Location
|
Purchasing Contact Information
|
Procurement Forms
Terms and Conditions of Purchase
|
Quality Assurance Requirements
